Philips MP3-WMA-CD playback Micro Hi-Fi System - Manual (Page 12)

12
English
Preparations
C Speakers Connection
Front Speakers
Connect the speaker wires to the SPEAKERS
terminals, right speaker to "RIGHT" and left
speaker to "LEFT", the wire (marked red) to
"
+" and the wire (marked black) to "-".
●
Fully insert the stripped portion of the speaker
wire into the terminal as shown.
Notes:
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of
+/- speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Before using the remote control
1
Pull out the plastic protective sheet.
2
Select the source you wish to control by
pressing one of the source select keys on the
remote control (for example CD, TUNER).
3
Then select the desired function (for example
Й,
н, л).
Replacing battery (lithium
CR2032) into the remote control
1
Pull out the knob
A
slightly to the left.
2
Pull out the battery compartment
B
.
3
Replace a new battery and fully inser t the
battery compartment back to the original
position.
CAUTION!
– Remove battery if it is exhausted or will
not be used for a long time.
– Battery contains chemical substances, so
they should be disposed of properly.
– Perchlorate Material-special handling
may apply. See www.dtsc.ca.gov/
hazardouswaste/perchlorate.
B
A A
PG 001-024_MCM108DB_37-Eng 26/4/07, 17:07 12