Philips 32PF9996-37 - Manual (Page 27)

23
To enhance the sound reproduction of your TV you can
connect an externally powered subwoofer (between 20 and
250 Hz).
& Connect the audio cable of the external subwoofer to
the
SUBWOOFER socket at the bottom of your TV.
é Select Subwoofer in the Settings, General menu, p. 8.
“ Adjust the frequency of the external subwoofer to 100-
120 Hz (according to your personal preference) if
present on the subwoofer.
‘ Adjust the volume level of the external subwoofer,
presumed this control is present on the subwoofer.
See also the instruction manual of the external
subwoofer.
SUBWOOFER
AUDIO
RECEIVER
R
L
CENTRE
SUBW.
MONITOR
OUT
AV3
VIDEO
R
L
R
L
HDMI
Camera, Camcorder, Game
& Connect your camera, camcorder or game as shown.
é Connect to VIDEO
2 and
AUDIO L
3 for mono
equipment. For stereo equipment also connect
AUDIO R
3.
S-VHS quality with an S-VHS camcorder is obtained by
connecting the S-VHS cables with the
S-VIDEO input
1 and
AUDIO inputs 3.
Do not connect cable 1 and 2 at the same time. This
may cause picture distortion !
Headphone
& Insert the plug into the headphone socket L as shown.
é Press ¬ on the remote control to switch off the
internal loudspeakers of the TV.
The headphone impedance must be between 8 and 4000
Ohm. The headphone socket has a 3.5 mm jack.
In the Sound menu select
Headphone volume to adjust
the headphone volume.
VIDEO
3
2
1
S•VIDEO
AUDIO
& Keep the AV+ button pressed and then press this button
repeatedly or select Source in the Settings menu (see p. 11) to
select AV1 , AV2 , HDMI (AV3) , Side or TV channels , according
to where you connected your devices.
é Press the cursor up/down.
“ Press OK . MODE ON/OFF Ambilight
7 8 9
0
CONTROL
ACTIVE
CLOCK SAP
AV+ -
To select connected devices
Side connections
Connect extra subwoofer