Philips 42PF9631D-37E - Manual (Page 17)

How to search for and store TV channels (continued)
EN
15
Available channels:
- Cable (analog NTSC or digital QAM): max. from 1 to 135
- Terrestrial (analog NTSC or digital ATSC): max. from 2 to 69
If a tuned channel is not yet in the master channel map, the
TV will attempt to tune the channel and it will be added to
the map.
If the channel is not acquired, a message will appear that the
channel is not available.
When you tune an audio-only digital subchannel, a display
appears with the message Audio only.
Channel tuning
Important: After the installation of the TV channels has been
done, always make a selection in the Installation menu
between Antenna or Cable whether you want to watch
Antenna TV channels or Cable TV channels.
Note: Do not start Autoprogram but press the red color
button.Then press the
MENU button.
If you make use of a signal splitter do not forget to put the
switch in the corresponding position.
Notes:
- Subchannel selections
The new standards employed with digital broadcasting make
it possible to receive multiple program channels under a
single major channel number which can be selected by
pressing the digit remote control direct-access channel
number entry.
- Digital Channel selection delay
Due to the tuning complexity of subchannel digital
programming, the time to select and view a digital channel
may take slightly longer than what the viewer is normally
accustomed to (as compared to analog channel programs).
Digital channel broadcasts contain program and system data
information that must be processed before the channel
selection can be displayed.