Philips 9FF2M4-37 User Manual
Page 10
Philips Electronics
- 9 -
1.2.6 Play Photos from Memory Card
A B
A. CF Card
B. SD/ MMC /MS / xD Card
Inserting a memory card:
•
Insert the memory card into the slot in the frame.
•
For a Compact Flash card, firmly slide card in the larger slot end first and face DOWN.
•
For a xD, SD, MMC, or Memory Stick card slide card in the smaller slot end first and
face UP until it locks in-place.
After a few seconds photos on the memory card will display and a slideshow will start.
Please DO NOT remove the memory card just after inserting it in PhotoFrame™ or when
PhotoFrame™ is counting the Photo. Wait until the screen is stable
Removing a memory card:
•
To remove the Compact Flash card, pull out the card slowly.
•
To remove the xD, xD, SD, MMC, or Memory Stick card, push the card again to unlock
and then pull out the card.
IMPORTANT NOTICE:
Philips PhotoFrame™ do not support memory stick Duo, PRO Duo and
RS-MMC even with adaptor
Note: To copy photo from the memory card to the PhotoFrame™ read the copying photo
section.
Tips: - Increase the memory of the PhotoFrame™ by permanently inserting permanently a
memory card into it.This allows the same functions as the internal memory to be
performed.
- Two memory card slots can be used at the same time; therefore one can be dedicated
for the extended memory, and the other slot for reading and copying pictures from the
camera memory card.
Note: To be able to delete photos on the memory card this function on the memory card must
be allowed. To do so read the “Setup- Memory card” section.