Philips 32PFL3506H-12 - Manual (Page 35)

31
English
Manually install digital
channels
You can search and store digital TV channels
one at a time.
1
Press .
2
Select [Setup] > [Channel settings]
> [Channel installation] > [Digital:
Reception test] > [Find channel], then
press OK.
3
Press the Numeric buttons to enter the
channel frequency.
4
Select [Search], then press OK.
5
When the correct channel is located, select
[Store], then press OK.
6
To exit, press .
Note
• If the reception is poor, reposition your antenna and
repeat the procedure.
•
If you receive the channel with DVB-C, select [Symbol
rate mode] > [Automatic], unless your cable provider
supplies you with a specific symbol rate value.
Rename channels
You can rename channels. The name appears
when you select the channel.
1
While you watch TV, press FIND.
» The channel matrix menu is displayed.
2
Select the channel to rename.
3
Press OPTIONS.
» The channel options menu appears.
4
Select [Rename channel], then press OK.
» A text input box appears.
5
Press to select each character,
then press OK.
6
When the name is complete, select
[Done], then press OK.
Tip
• Press [Aa] to change an uppercase letter to a
lowercase letter and vice versa.
Manually install analogue
channels
You can search and store analogue TV channels
one at a time.
Step 1: Select your system
Note
• If your system settings are correct, skip this step.
1
Press .
2
Select [Setup] > [Channel settings]
> [Channel installation] > [Analogue:
Manual antenna installation] > [System],
then press OK.
3
Select the correct system for your country
or region, then press OK.
Step 2: Search and store channels
1
Press .
2
Select [Setup] > [Channel settings]
> [Channel installation] > [Analogue:
Manual antenna installation] > [Find
channel], then press OK.
• If you know the three-digit frequency
of the channel, enter it.
• To search, select [Search], then press
OK.
3
When the channel is found, select [Done],
then press OK.
• To store the channel as a new number,
select [Store as new channel], then
press OK.
• To store the channel as the previously
selected channel, select [Store
current channel], then press OK.
Step 3: Fine-tune channels
1
Press .
2
Select [Setup] > [Channel settings] >
[Analogue: Manual antenna installation] >
[Fine-tune], then press OK.
3
Press to fine-tune the channel.
EN