Philips 22PFL4907-F7 - Manual (Page 31)

English
31
*You can set a particular about picture quality in Advanced picture.
Auto picture Color alignment Mode
Noise reduction Minimum
Black stretch On
Dynamic contrast Off
Gamma
MPEG artifact reduction Off
Color enhancement
Off
Custom color managem Red
Backlight
Contrast
Brightness
Color
Tint
Sharpness
Advanced picture
Color
alignment
Mode
to set the color temperature to
Personal, Cool, Normal and Warm
When you adjust the following
settings, Personal will be set
automatically.
Cursor ◄ Cursor ►
Red gain
to decrease
contrast with red
to increase
contrast with red
Green gain
to decrease
contrast with
green
to increase
contrast with
green
Blue gain
to decrease
contrast with blue
to increase
contrast with blue
Red offset
to decrease
brightness with
red
to increase
brightness with
red
Green offset
to decrease
brightness with
green
to increase
brightness with
green
Blue offset
to decrease
brightness with
blue
to increase
brightness with
blue
Noise
reduction
to select the desired setting, then press OK
(Off, Minimum, Medium, Maximum and Auto)
Black
stretch
to select the desired setting, then press OK
(Off, Minimum, Medium and Maximum)
Dynamic
contrast
to select the desired setting, then press OK
(Off, Minimum, Medium and Maximum)
Gamma
Cursor ◄ Cursor ►
to adjust the gamma encoding of images
MPEG
artifact
reduction
to select the desired setting, then press OK
(Off, Minimum, Medium and Maximum)
Color
enhancement
Off to set color enhancement to Off
On to make colors more vivid and bright
Custom
color
management
to select the desired setting, then press OK
(Red, Yellow, Green, Cyan, Blue and Magenta)
Cursor ◄ Cursor ►
Tint
to rotate only
selected color
tint in clockwise
direction
to rotate
only selected
color tint in
counterclockwise
direction
Saturation
to decrease color
with only selected
color
to increase color
with only selected
color
Brightness
to decrease
brightness with
only selected
color
to increase
brightness with
only selected
color
Film mode
Off to set film mode to Off
Auto
to optimize the picture recorded by
the original film
Note
• Mode selection is available only if
– the external Input modes are selected HDMI 1, HDMI 2 or HDMI 3.
– the connected HDMI device is outputting a video signal.