Philips 22PFL4907-F7 - Manual (Page 12)

English
12
Connecting the antenna or the cable
Be sure your antenna or other device is connected properly before
plugging in the AC power cord.
If you connect to an antenna through RF cable
Any DTV programs that are broadcasted in your area can be received
for free through an antenna connection.
IN IN
OUT antenna
RF cable
cable
If you connect a set-top box through RF cable
If the TV is connected to a cable box or satellite set-top box via a
coaxial connection, set the TV to channel 3, 4 or the channel specified
by the service provider.
IN
IN IN
OUT
set-top box
RF cable
antenna
RF cable
If you connect a set-top box through HDMI
If the TV is connected to a cable box or satellite set-top box via HDMI,
make sure you select the correct Source by using SOURCE.
IN
IN IN OUT
set-top box
HDMI cable
RF cable
If you connect a set-top box through Component Video Input
If the TV is connected to a cable box or satellite set-top box via
Component Video Input, make sure you select the correct Component
Video Source by using SOURCE.
IN
OUT OUT
IN IN
IN IN
OUT OUT
set-top box
RF cable
Audio (L/R) cables
Component (Y/Pb/Pr) Video cables
Connecting a set-top box, Blu-ray / DVD recorder via
composite connectors and Analog Audio
Do not place your recorder too close to the screen because some
recorders can be susceptible to signals.
IN IN
OUT
OUT OUT
IN IN
IN IN
OUT
IN
OUT OUT
RF cable
RF cable
cable
set-top box
Blu-ray disc / DVD recorder
Audio (L/R) + Video cables
Audio (L/R) +
Video cables
Note
• If you have any question about the DTV’s antenna, visit www.antennaweb.org for further
information.
• Depending on your antenna system, you may need different types of combiners
(mixers) or separators (splitters) for HDTV signal. The minimum RF bandpass on these
devices is 2,000MHz or 2GHz.
• For your safety and to avoid damage to this unit, please unplug the RF coaxial cable
from the antenna Input jack before moving the unit.
• If you did use an antenna to receive Analog TV, it should also work for DTV reception.
Outdoor or attic antennas will be more effective than a set-top box or inside antenna.
• To Turn On your reception source easily between antenna and cable, install an antenna
selector.
• If you are not receiving a signal from your cable service, contact the Cable provider.
• Only the left loudspeaker reproduces sound for mono equipment. Use a mono to
stereo adapter (not supplied) for sound reproduction via all internal loudspeakers.
Plugging in the AC power cord
Make sure that the AC power cord must be plugged to an AC outlet
after all the necessary connections are made.
Caution
• Do not connect the AC power cord to a power supply outside the indicated voltage of
this unit (AC 120V).
• Connecting the AC power cord to a power supply outside of this range may result in
fire or electrical shocks.
Note
• Each time you plug in the AC power cord, no operations will be performed for a few
seconds. This is not a malfunction.