Philips LCD TV 32PFL3506 81cm-32" digital TV with Digital Crystal Clear - Manual (Page 7)

7 EN
English
A17FHUH / A17FGUH_32PFL3506_F7
If you connect a set-top box through component video input
If the TV is connected to a cable box or satellite set-top box
via component video input, make sure you select the correct
component video source by using SOURCE on this unit’s
remote control.
IN IN
OUT
OUT OUT
YPbPr
IN
OUT
IN
set-top box set-top box
RF cable RF cable
audio L/R audio L/R
YPbPr YPbPr
Connecting a set-top box, DVD recorder via
composite connectors and analog audio
RF IN
IN
OUT
OUT
RF IN RF IN RF IN
RF OUT RF OUT RF OUT
IN IN IN
DVD recorder
audio L/R + video audio L/R + video
set-top box set-top box
cable
Do not place your recorder too close to the screen because
some recorders can be susceptible to signals.
Note
• Only the left loudspeaker reproduces sound for mono equipment. Use a
mono to stereo adapter (not supplied) for sound reproduction via all internal
loudspeakers.
• When you connect cables, match the cable colors to the connectors on the TV.
4 Use your TV
Still mode
You can pause the image shown on the TV screen.
Press FREEZE to pause the image shown on the TV screen.
Freeze
• The sound output will not be paused.
• If no signal is detected or protected signal is received
during still mode, the image remains paused and the sound
output will be muted.
• The still function will be released after 5 minutes.
To cancel still mode, press any button except
. (standby-On).
Watching channels from a set-top box
To watch channels from a set-top box
1
Switch on the set-top box.
»
The picture from your set-top box might appear
automatically on the TV screen.
2
Use the remote control of your set-top box to select
channels.
If the picture does not appear
1
Press SOURCE repeatedly to select the set-top box and
wait a few seconds for the picture to appear.
2
Use the remote control of your set-top box to select
channels.
Watching connected devices
To watch connected devices
1
Switch on the connected device.
»
The picture from your connected device might
appear automatically on the TV screen.
2
Use the remote control of the device to select channels.
If the picture does not appear
1
Press SOURCE repeatedly to select the connected device
and wait a few seconds for the picture to appear.
2
Use the remote control of the device to select channels.
Automatic Power Shut Off
If there is no input signal and no operation for 15 minutes, the
unit will turn off automatically.
LC9__46_40PFL3706+++32PFL3506_EN.indd 7 LC9__46_40PFL3706+++32PFL3506_EN.indd 7 2011/05/30 11:44:50 2011/05/30 11:44:50