Bosch WFMC4301UC - Manual (Page 20)

20
i If the spin speed is too high, the
Start/Pause indicator light is lit
(red). Laundry can be added in
Pause" mode when the drum is at
a standstill.
Canceling an active
program
If you would like to terminate a program
and remove the laundry:
i If a program is interrupted at a high
temperature, leave the laundry to
cool down until the glass is cool to
touch.
q Turn the program selector to Off.
q Turn the program selector to Drain
or Spin.
i For Spin, select the desired spin
speed (but not no final spin).
q Press the Start/Pause button.
q Wait until this program ends.
q Open the door.
q Unload the laundry.
i If a program is interrupted at a high
temperature, the door may remain
locked until the appliance has
cooled down.
i If the program is terminated by
switching off the appliance, the
door may remain locked.
After Washing
The Start/Pause indicator light goes
out.
0:00
appears in the display.
q Open the door.
q Turn the program selector to Off.
q Close the taps.
q Remove the laundry.
If No final spin" preselected
The Start/Pause indicator light flashes.
q Turn the program selector to
Drain. The Start/Pause indicator
light flashes.
q Press the Start/Pause button.
The indicator light is lit.
q When this program has ended,
open the door.
q Turn the program selector to Off.
q Close the taps.
q Remove the laundry.
i Leave the loading door ajar to
allow the inside of the washing
machine to dry.
Cleaning and
Care
Cleaning the washer
d
WARNING
d
TO AVOID RISK OF ELECTRIC
SHOCK!
Always disconnect the appliance
from the power outlet before
cleaning.
Never clean the washing machine
with a pressure washer.
d
WARNING
d
TO AVOID RISK OF EXPLOSION!
Never use flammable solvents to
clean the appliance.
CAUTION
Occasionally check for any foreign
objects (e. g. coins, paper clips)
between the drum and rubber seal
-TO AVOID Risk of rust!
Cleaning the appliance housing
and control panel
As required:
q Use hot soapy water or a mild,
nonĆabrasive cleaning agent.
q Rub dry with a soft towel.
Cleaning the drum
If rust spots have formed due to
leftĆover debris (e.g. coins, paper clips,
nails):
q Use a chlorineĆfree cleaning agent.
Follow the manufacturer's
instructions. Never use steel wool.
Cleaning the detergent dispenser
If residual detergents or additives have
accumulated
or if softener/bleach are not fully rinsed
out:
q Open the flap of the detergent
dispenser.