Bosch WFMC4301UC - Manual (Page 19)

19
Washing
q Turn on the water taps.
q Turn the program selector to the
desired program.
q Load the washing machine and
close the door.
The Start/Pause indicator light
flashes (red).
q If necessary, press the button(s) for
additional option(s).
The indicator light of the selected
button is lit (red).
i If an incorrect combination was
inadvertently selected, the
indicator light of the selected
button is turned off.
q If necessary, change the spin
speed with the Spin selection
button until the the desired spin
speed indicator light is lit.
q If necessary, change the Start
time. Press the Delay Start button
until the desired Start time is
displayed.
q Press the Start/Pause button.
The indicator light is lit (red).
Display shows the run time of the
selected program. The program
starts.
i Each program step is indicated by
the indicator lights under the
display.
During Washing
i Due to the highly engineered
suspension of this appliance, it
may experience a shudder or
shake when progressing from
lower to higher spin speeds.
This behavior is normal due to
shifting of the drum system and
should not cause concern.
Changing a program
q Turn the program selector to Off.
q Turn the program selector to a
newly selected program.
The Start/Pause indicator light
flashes.
q If required, change the settings;
see from Page 17.
q Press the Start/Pause button.
The program starts.
The indicator light is lit.
Add a garment /
Interrupting the program
You can put laundry in the drum after
washing begins, take laundry out of the
drum early or interrupt the program at
any time.
i It is not recommended to add
laundry after the washing phase is
complete.
i You can add or reduce laundry as
long as the Start/Pause indicator
light flashes (red).
q Press the Start/Pause button.
The Start/Pause indicator light
flashes.
q Open the door.
q Place/remove the laundry.
q Close the door.
q Press the Start/Pause button.
The program continues.
The indicator light is lit (red).
i When the Start/Pause indicator
light is lit (red), the program can be
interrupted, however the door
cannot be opened for safety
reasons (water level, temperature
or speed too high).