BT 4100 - Manual (Page 75)

1. Press or , TXT Menu is displayed. Select the OK option.
2. Write Message is displayed. Select the OK option.
3. Use the keypad to type in the following commands
(depending upon what you want to do):
Opt out from receiving voice text messages.
Turns off the opt out option.
Turns on permanent voice text message delivery to your phone.
All incoming text is delivered as voice text.
Turns off permanent voice text message delivery.
4. Select Opt . Send To is displayed, select OK .
5. Enter 00000 and select OK .
6. Text is highlighted, select OK . The display shows Sending Message .
If you are sending a message from a fixed line phone to another fixed line phone
• Forces a message you send to be delivered as a voice text even though the
recipient may have a text enabled phone and usually receives written text. This command
is inserted at the start of the message and applies only to that message, e.g.
‘Hello I will be home late’.
If you are sending a message from a fixed line phone and require a status report
• Will allow a status report to be sent back to youwhen you have sent a
message to confirm delivery.
• Place at the start of your text message. Write the message and send it.
You will receive a reply text back to your phone giving the status report for that message.
You keep hearing an error beep
• You have pressed the wrong button in a sequence. Check the prompts in the display or
refer to instructions in this user guide.
0
3
3
3
2
2
1
1
Menu
Menu
Help 75
Synergy 4100 – Issue 3 – Edition 1 – 21.08.06 – 7771
If you experience any problems, please call the Helpline on 0870 605 8047 or email [email protected]