Bosch WVT 52458 - Manual (Page 39)

B
37
B
B B
A A
Operating Instructions
Installation location
Removing the transport bolts
To ensure the proper operation of the washer-dryer, please
pay attention to the following when you install the machine.
The floor should be solid and flat, never put the machine
on the soft carpet or on the wood floor.
The transport bolts must always be removed before using the
appliance for the first time and must be retained for any sub-
sequent transport (e.g. When moving)
Use the spanner provided only if a ring spanner is unavailable.
Keep the environment dry and vented.
Never put small appliance, such as microwave oven; and/
or jar cooker, on the machine.
Keep the machine away from the flaming equipment, such
as candle, cooking stove, liquefied gas container etc.
Never put the pressure containers on the machine.
In the case of suspended wooden floors, place the machi-
ne on a water-resistant wooden board (plinth ) of at least
30mm thicknees which is screwed to the floor. If possible,
install the machine in a corner of the room. Secure the
machine s feet with brackets (this applies partcularly to
tower arrangements).
Never put the machine over the opening of uncovered
drainage.
If the machine is installed on a plinth, the machine s feet
must be secured with brackets to prevent it sliding when
spinning.
Loosen all four transit bolts with the wrench until they are
freely movable.
If not all parts have been removed and have falled into the
button of the washer-dryer: open the door, pull the drum
forwards slightly, reach in and remove the parts.
,
,
Loosen all four transit bolts with the wrench until they are
freely movable.