Philips Luftreiniger User Manual

Page 17

ENGLISH

Discard the filter that needs to be replaced and unpack the new

filter.

Note: Do not touch the pleated filter surface, or smell the filter as it has

collected pollutants from the air.
Note: Wash your hands after disposing of the used filters.

Put filter 2 (multi-layer filter) back into the appliance.

Note: Make sure that the side with the tag is pointing towards you.

Put filter 1 (pre-filter) back into the appliance.

Note: Make sure that the side with the two projections is pointing towards you.
Note: Make sure that all hooks are properly attached to the appliance.

To reattach the front panel, insert the bottom hooks into the bottom

of the appliance first (1). Then push the panel against the body of the

appliance (2).

Put the plug in the wall socket and switch on the appliance again.

Press the filter reset button with a thin tool.

Note: You do not need to press the filter reset button after cleaning filter 1

(pre-filter).
Note: You cannot reset the appliance when you replace a filter before its filter

replacement light starts flashing.
Note: You cannot reset the appliance if it is not plugged in and switched on.

Storage

To store the mains cord, wind it round the cord storage facility at the

bottom of the appliance.