Philips Luftreiniger User Manual

Page 14

ENGLISH

Clean the pre-filter by removing the dust with a vacuum cleaner.

Tip: Alternatively, you can wash the pre-filter under a running tap. If the

pre-filter is very dirty, use a soft brush to brush away the dust. In this case,

make sure that the pre-filter is completely dry before putting it back into the

air purifier. If it is still wet, bacteria may multiply in it and shorten the lifetime

of the pre-filter.

Put the pre-filter back into the appliance. Attach all hooks properly

to the appliance.

Note: Make sure that the side with the two projections is pointing towards you.

To reattach the front panel, insert the bottom hooks into the bottom

of the appliance first (1). Then push the panel against the body of the

appliance (2).

Air quality sensor
Clean the air quality sensor every 2 months for optimal functioning of

the appliance. Clean it more frequently if you use the appliance in a dusty

environment.
Note: When the humidity level in the room is very high, it is possible that

condensation develops on the air quality sensor. As a result, the AIR QUALITY

light on the control panel and the air quality light ring may indicate that the air

quality is bad even though the air quality is good. In this case you have to clean

the air quality sensor or use one of the manual speed settings.

Clean the air quality sensor inlet and the air quality sensor

outlet with a soft brush.

Remove the air quality sensor cover.