Philips Saeco Nina Siebträger-Espressomaschine - Manual (Page 20)

• 20 •
of the steam / hot water wand.
12 After dispensing water, switch the selection knob (17) to the
“ ” position in order to stop the dispensing. Close the water
dispensing knob (4) by turning it clockwise.
13 Repeat the operations once again from point (8) for a total
of 4 tanks.
14 (Fig.16) - Remove the portafi lter from the unit by turning it
from right to left and rinse it with fresh drinking water.
The descaling cycle is now complete.
(Fig.2) - Fill the tank again with fresh water. If necessary, prime
the circuit as described in Section 4.5 of the manual.
Saeco descaling solution should be disposed
of according to the manufacturer instructions
and/or the regulations in the country of use.
11 CAPPUCCINATORE OPTIONAL
Not all machine models are provided with cappuccinatore. The
cappuccinatore allows you to easily and quickly prepare deli-
cious cappuccinos.
Follow these simple instructions to install it.
1 (Fig.29) - Loosen the ring nut on the upper part of the cap-
puccinatore.
2 Insert the cappuccinatore completely into the steam spout.
3 (Fig.30) - Tighten the ring nut.
To use the cappuccinatore, prepare the machine as described
in the related sections.
Before using the accessories, we recommend washing them
with water (Fig.31-32), immerse the suction pipe in a fresh
water container and eject a small quantity of steam (please re-
fer to the related instructions). In this way, the accessories will
be perfectly clean before use.
To clean the cappuccinatore, suck up clean wa-
ter to clean the suction pipe.
While the machine is getting ready, prepare a special con-
tainer with milk or use the milk container. Place it beside the
machine.
• (Fig.33) - Immerse the suction pipe in the prepared milk.
• (Fig.34) - Eject steam as described in section 8. Turn the pin
to modify the milk froth.
Lift the pin gently to obtain more froth.
• After preparing the cappuccino, immerse the suction pipe
into a container with fresh clean water and eject steam. The
cappuccinatore is clean when clean water is dispensed. Clean
the suction pipe externally with a damp cloth.
The cappuccinatore must be removed and com-
pletely washed once a week.
Wash the cappuccinatore as follows:
• (Fig.35) - Remove the extremity of the cappuccinatore from
its seat.
• Separate the cappuccinatore’s components.
Warning. Do not use steam when the extrem-
ity of the cappuccinatore is not inserted into its
seat.
• (Fig.36) - Wash the cappuccinatore extremity with luke-
warm water. Make sure no dirt is left inside.
After washing the components of the cappuccinatore, place it
back on the coupling located on the machine.
12 DISPOSAL
• Put unused appliances out of service.
• Disconnect the plug from the socket and cut the electrical
cord.
• At the end of its life, take the appliance to a suitable waste
collection site.
This product complies with EU Directive 2002/96/EC.
The symbol on the product or on its packaging indi-
cates that this product may not be treated as household waste.
Instead it shall be handed over to the applicable collection point
for the recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inap-
propriate waste handling of this product. For more detailed in-
formation about recycling of this product, please contact your
local city offi ce, your household waste disposal service or the
shop where you purchased the product.