Bunn ES.1A - Manual (Page 8)

BUNN Espress™ Model ES•1A™
6
Chassis
The chassis of the ES•1A™ is made of painted steel and the work tray is stainless steel. To reach the
interior of the machine, proceed as follows:
• Remove the cup heater tray (1)
• Loosen the two screws (2) holding the side panel in place (2)
• Remove the side panel (3) by lifting it up carefully.
• By loosening the nut (4) that holds the control panel in position and by placing the front piece at a right
angle, access to the interior of the control panel is obtained.
• Finally, by removing the work tray (5) and the drainage tray (6), access is gained to all the elements
of the machine.
5
6
1 4
Technical features
2
3
Width ......................... 400 mm(15.7 inches)
Height ........................ 370 mm(14.5 inches)
Depth ......................... 490 mm(19.3 inches)
Net weight ................. 30 kgs(66.12 lbs.)
Gross weight ............. 37 kgs(81.55 lbs.)
Hydraulic feed ............
3 ⁄
8
"-19 Straight pipe BSPP
Drainage .................... 25 mm (1.07 in)
Total brewer power .... 2000 W.
Electric feed ............... 120 V. Single phase
Consumption ............. 16.7 A.
Boiler capacity ........... 4.0 liters (1.05 gal)
FEATURES
P-159