beautypg.com

Bunn CW-APS User Manual

Page 20

background image

Page 20

SERVICE (cont.)

START SWITCH

P0150.50

Location:

The start switch is located in the front of the

hood just to the right of center.

Test Procedure:
1. Disconnect the brewer from the power supply.
2. Disconnect the blue wire from the top switch

terminal and the white/red wire from the bottom
switch terminal.

3. Check for continuity across the two terminals on

the switch when it is held in the lower position.
Continuity must not be present across these ter-
minals in the upper position.

P1133

10690 062300

If continuity is present as described, reconnect the
blue wire to the top terminal and the white/red wire to
the bottom terminal.
If continuity is not present as described, replace the
switch.

Removal and Replacement:
1. Remove the blue wire and white/red wire from the

start switch.

2. Compress the clips inside the hood and gently

push the switch through the opening.

3. Push new switch into the opening and spread the

clips to hold the start switch in the hood.

4. Refer to Fig. 11 when reconnecting the wires.

FIG 10 START SWITCH

BLU to BLU Lead from
Timer P1

WHI/RED to ON/OFF
Switch

FIG. 11 START SWITCH TERMINALS

This manual is related to the following products: