Philips SENSEO® Twist Kaffeepadmaschine - Manual (Page 19)

19
4
Put a bowl with a capacity of at least 2 litres
under the spout to collect the water.
5
Press the 1-cup button q and the 2-cup
button qq at the same time for 3 seconds
until you hear a beep to start the flushing
cycle.
6
Remove the used pod and clean the pod
holder after the flushing cycle to prevent the
sieve in the centre from getting clogged.
7
Repeat steps 1 to 6 to ensure a clean
machine.
8
After the descaling cycle and the flushing
cycles, the CAlC light goes out and the
machine switches off automatically. You can
now reinsert the BRITA MAXTRA filter
cartridge into the water reservoir.
2L
• The CALC light and the on/off button start
flashing to indicate that the descaling cycle
is in progress.
• During the descaling cycle, the water comes
out of the machine in intervals.
• When all the water in the water reservoir
has been used up, the descaling cycle is
finished. The on/off button starts to flash
rapidly.
8.2 Flushing after descaling
1
Rinse the water reservoir under the tap and
then fill it to the top with fresh tap water.
D Notes:
• Do not place the BRITA MAXTRA filter
cartridge in the water reservoir.
• Do not refill the water reservoir with
used hot water or the used descaling
mixture.
2
Tilt the water reservoir and place the bottom
back onto the machine (1). Then press the top
of the water reservoir towards the machine (2).
3
Place the 1-cup pod holder q with a used
coffee pod in it in the coffee machine. Close
the lid and make sure it is properly locked.
ENG
lIS
h