Body Solid G6B - Manual (Page 22)

7
Be careful to assemble all components
in the sequence they are presented.
mm
Inch
22
S T E P
A. Attach Pulley Platform (AB) to Main Base Frame (A) as shown using:
Two 50 (3/8” x 1” hex head bolt)
Four 74 (3/8” washer)
Two 71 (3/8” nylon lock nut)
B. Attach two Pulley Swivels (AC) to Pulley Platform (AB) as shown using:
Two 59 (3/8”x 5/8” round allen head bolt)
Two 74 (3/8” washer)
Insert two Curved End Caps (3) into Pulley Platform (AB) as shown.
C. Insert two Curved End Caps (3) into Seat Pad Frame (W) as shown.
Attach Seat Pad (AD) to Seat Pad Frame (W) using:
Two 62 (5/16” x 1 3/4” hex head bolt)*
Two 77 (5/16” spring lock washer)
Two 76 (5/16” washer)
*Do NOT over-tighten these bolts. Tighten these bolts untill spring lock washer is flat.
Over - tightening these bolts will cause T - nuts in pads to strip out.
D. Slide 4”x 8” Foam Rollers (18) onto Foam Roller Bar (38) and attach to Seat Pad Frame (V). Hold
Foam Rollers (18) in place with 3” Plastic Washer (8) on the inside and Plastic Roller End Cap (5)
on the outside as shown.
E. Slide Foot Brace Adjuster (AE) into Main Base Frame (A) and hold in place with Pop Pin (63).
F. Attach Foot Brace (AF) to Foot Brace Adjuster (AE) with Shaft (64).
Tighten Allen Screws (34).
Insert Round End Caps (27) to Foot Brace Adjuster (AE), and attach Grip Tape (16) to
Foot Brace (AF) as shown.
Note:
You should now wrench tighten all bolts and nuts in this step.
Do NOT re-tighten any of the pad bolts.