Body Solid G6B - Manual (Page 12)

mm
Inch
2
Be careful to assemble all components
in the sequence they are presented.
12
S T E P
A. Attach Angled Support Frame (D) to Main Base Frame (A) using:
Two 40 (1/2” x 3 1/4” hex head bolt)
Four 73 (1/2” washer)
Two 70 (1/2” nylon lock nut)
B. Insert Convex End Cap (4) to the front of the Top Frame (E).
Attach Top Frame (E) and Plate (67) to the Rear Vertical Frame (C) using:
Two 40 (1/2” x 3 1/4” hex head bolt)*
Three 73 (1/2” washer)
One 70 (1/2” nylon lock nut)
*NOTE:
One bolt (40) goes into an internally threaded nut inside Top Frame (E).
C. Attach Top Frame (E) and Plate (68) to Angled Support Frame (D) using:
Two 43 (1/2” x 4 1/4” hex head bolt)
Four 73 (1/2” washer)
Two 70 (1/2” nylon lock nut)
D. Insert Convex End Cap (2) to the small horizontal arm on Angled Support Frame (D) as shown.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until end of step 3.