Body Solid G6B - Manual (Page 16)

4
Be careful to assemble all components
in the sequence they are presented.
mm
Inch
16
S T E P
A. Attach two Convex End Caps (2) to the top of Seated Press Arm Support (H).
Attach Seated Press Arm Support (H) to Top Frame (E) using Shaft (33), and tighten
Allen Screws (34).
B. Attach Bi Angular Bars (J) to Top Frame (E) using:
Two 53 (3/8” x 3” hex head bolt)
Four 74 (3/8” washer)
Two 71 (3/8” nylon lock nut)
Also using:
Two 80 (3/8” x 1/2” hex head bolt)
Two 79 (3/8” washer)
C. Attach Press Arm Holder (K) to Seated Press Arm Support (H) using Shaft (35), and tighten
Allen Screws (34).
D. Attach Left Press Arm (L) to Press Arm Holder (K) using Shaft (KA), and:
One 37 (1/2” x 3/4” hex head bolt)
One 73 (1/2” washer)
And tighten Allen Screws (34).
E. Attach Right Press Arm (M) to Press Arm Holder (K) using Shaft (KB), and:
One 37 (1/2” x 3/4” hex head bolt)
One 73 (1/2” washer)
And tighten Allen Screws (34).
F. Connect Bi Angular Bars (J) to Left Press Arm (L) using Shaft (39) and:
Two 74 (3/8” washer)
Two 36 (3/8” x 5/8” round allen bolt)
G. Connect Bi Angular Bars (J) to Right Press Arm (M) using Shaft (39) and:
Two 74 (3/8” washer)
Two 36 (3/8” x 5/8” round allen bolt)
Note:
You should now wrench tighten all bolts and nuts in this step.