New Buck Corporation 81 - Manual (Page 27)

Page 25
TOOLS FOR INSTALLATION
Drop cloth, 3/32" Metal drill bit, 5/16" magnetic socket chuck adapter, 5/16" wrench (box or socket) or adjustable
wrench, Jigsaw with masonry, metal and wood blades
WARNING: DO NOT INSTALL IN A SLEEPING ROOM
PREPARING STOVE FOR INSTALLATION
1. Remove protective plastic wrapping from unit, inspect unit for any obvious physical damage.
2. Plug power cord into a 115V AC outlet to test motor and fan when optional motor is being used. “Do not run cord
under unit or in high traffic areas”.
3. Check primary air draft control to ensure that it slides freely. (See Figure 12).
4. Remove any items from within firebox. Spread a dropcloth on floor behind heater. Next, tilt heater so that back
is on drop cloth.
5 . ( Leg Kit ): If legs are to be used, obtain four legs, attach legs to holes in bottom of unit with bolts and
washers supplied with leg kit. (See Figure 12).
6. ( Pedestal Kit ): If pedestal kit is being used (and out side air is required see below, Out Side Air Installation).
Before attaching heater to stand, take a large flat screwdriver or pliers and remove the 2" x 2" knockout on
bottom of unit. (See Figure 12A). Open freestanding kit and obtain stand. Place stand against bottom of heater
(angle side to heater).Center stand front to rear and also center stand left and right. Mark screw locations on bottom
of stove through outer holes of stand mounting angles. Set stand aside and drill four 7/32" holes in heater bottom.
Then mount stand to bottom of heater with screws provided. (See Figure 12A).
7. Obtain four (4) 3/16" self-tapping screws and secure stand to heater.
8. Reposition heater to upright position.
Figure 12
HOLES FOR MOUNTING PEDESTAL
Figure 12A
Out Side Air Installation
CAUTION
THE STRUCTURAL INTEGRITY OF MOBILE HOME FLOOR MUST BE MAINTAINED. (MOVE OPENING
AND/OR REPOSITION HEATER LOCATION IFNECESSARY).
1. Select an installation location that will give best airflow from front of heater to remainder of home.
2. Place protective floor pad in position. For minim floor protection (See Page 24).
2" x 2"
KNOCKOUT
PRIMARY AIR
DRAFT CONTROL PEDESTAL