New Buck Corporation 81 - Manual (Page 25)

INSTALLATION OF (OPTIONAL) CLOSE
CLEARANCE SHIELDS
1. Center rear close clearance shield with back of stove. Mark rear of stove, using reference
holes in rear shield. Using self-tapping screws, drill four holes in locations marked. Remove
screws and attach rear shield to back of stove. (See figure 11a).
2. Insert front end of side shield behind side angle on front side of stove. Align top of side
shield with top of rear shield. Mark holes on rear shield thru holes in rear of side shield. Us-
ing four self tapping screws, drill four holes in the locations marked. Tighten bottom screws
and leave top screws loose for step 3. Use same step to install side shield on opposite side of
stove. (See figure 11b).
3. Loosen two top screws holding side shield at rear top. Insert pipe shield where back shield
and top rear side shield meets. Tighten screws. (See figure 11c).
REAR CLOSE
CLEARANCE SHIELD
SIDE SHIELD’S
PIPE SHIELD
Figure 11a Figure 11b
Figure 11c
Side angle
on front side
of stove.
C L
Keep rear / side
shields even
Page 23