Wall-mounting template – BT 2100 User Manual

Page 27

Text mode
Original mode

If wall mounting your Synergy 2100,
use this guide for position.

• Make sure that you are not drilling

into any hidden wiring and check
that the power cable will reach from
the mains socket to the charging
cradle.
Switch the power adaptor off at the
mains and remove the adaptor plug
from its socket.

• Drill two holes 25mm deep using a

3mm drill, 24mm apart to take the
wall plugs.

• Put wall plugs into the drill holes

and then insert both screws. Leave
2-3mm between the head of the screw
and the wall. You are now able to
mount the charging cradle.

• Fit the charger onto the two screws.

If necessary, tighten or loosen the
screws for the best fit.

• Put the handset back in the

charging cradle and switch the
power back on at the wall socket.

Wall-mounting template

24 mm

WALL

WALL PLUG

SCREW

24mm

Synergy 2100 - Edition 3 – 31st May ’00

ALL

-MOUNTING

Synergy 2100 1/6/2000 3:07 pm Page 21