BT 2100 User Manual
Page 16
12
Registering a new
Synergy 2100 handset
with the base station
It is essential that you register your
handset with your Synergy base station
for it to work.
This and each further additional
handset you purchase must be
registered at the base station in order
for them to work.
As well as your original handset, you
can register up to a further 4 additional
handsets to your Synergy 2120 or 2150
base station.
The system allows internal calls
between the handsets while a third is
making an external call.
The instructions in this section are for
registering an additional Synergy 2100
handset with one base station. If you
have a system with more than one base
station, please follow the procedure in
the section “Operating with additional
base stations”
in your main Synergy
base station user guide.
If you have a Synergy 2120 or
Synergy 2150, it comes supplied with
one handset which is automatically
registered as handset number one.
Please note
When switched on, a new additional
handset will display Not SUB.
This tells you that the handset is not
yet registered with the base station.
5
To register your new handset
to the base station
At the base station:
Press the
PAGE
button and
hold for at least 10 seconds,
until you hear the validation
tone, then release the button.
The In Use LED on the base
will flash repeatedly. You
must register the handset in
the next 10 minutes.
At the handset:
Until the display flashes
Registration
.
Press to display the available
base station names
BASE 1-4
.
If your handset is already
registered to another base
then the display shows
*
next to the base name.
Options
Options
Page
Synergy 2100 - Edition 3 – 31st May ’00
SETTING UP
Del
Del
Synergy 2100 1/6/2000 3:07 pm Page 10