Buffalo Technology WBR2-G54S - Manual (Page 83)

83
29. At the top of the page, press the ‘Apply’ button.
30. Once the router has rebooted, click on the ‘Management’ tab on the left.
31. Click on the ‘PING test’ link on the left.
32. In the ‘Destination’ fi eld enter the IP address of the second access point and press the ‘OK’ button.
a. If the ‘Result’ section of the table reports information like, “1st: 64 bytes from IP_ADDRESS” then
the WDS bridge is effectively working.
b. If the ‘Result’ section of the table reports “Destination Host Unreachable”, then an error has oc-
curred during the setup.
WDS is a complicated bridging system with a lot of variables. If there are still problems with WDS con-
fi guration on the network, then please call our 24/7 technical support line at 1-866-752-6210.
Troubleshooting