5disposing of packaging, 6connecting the appliance, 7switching on the appliance – Liebherr CBNPgb 3956 Premium BioFresh NoFrost User Manual
Page 10: 1switching on the freezer compartment, 5control, 1brightness of the temperature display, 1adjusting the brightness, 2child proofing, 1setting the child lock function, 3door alarm

4.5 Disposing of packaging
WARNING
Danger of suffocation due to packing material and plastic film!
u
Do not allow children to play with packing material.
The packaging is made of recyclable materials:
-
corrugated board/cardboard
-
expanded polystyrene parts
-
polythene bags and sheets
-
polypropylene straps
-
nailed wooden frame with polyethylene panel*
u
Take the packaging material to an official collecting point.
4.6 Connecting the appliance
NOTICE
Risk of damage to the electronic control system!
u
Do not use stand-alone inverters (conversion of d.c. to a.c./
three-phase) or energy saving plugs.
WARNING
Fire and overheating hazard!
u
Do not use extension cables or multiple socket outlets.
The type of current (alternating current) and voltage at the
installation site have to conform with the data on the type plate
(see Appliance at a glance).
The socket must be properly earthed and fused. The tripping
current for the fuse must be between 10 A and 16 A.
The socket must be easily accessible so that the appliance can
be quickly disconnected from the supply in an emergency. It
must be outside the area of the rear of the appliance.
u
Check the electrical connection.
u
Plug in the power plug.
4.7 Switching on the appliance
Note
u
To switch on the entire appliance it is necessary only to
switch on the freezer compartment.
Switch on the appliance approx. 2 hours before
adding frozen food for the first time.
Do not load food to be frozen before the tempera-
ture display reads -18 °C.
4.7.1 Switching on the freezer compartment
u
Press On/Off button, freezer compartment
Fig. 3 (17)
.
w
The temperature display of the refrigerator compartment
indicates the current temperature inside.
w
The temperature display of the freezer compartment and the
alarm symbol flash until the temperature is sufficiently low. If
the temperature is above 0 °C, dashes flash. If it is below,
the current temperature flashes.
w
If “DEMO” is displayed, demo mode is activated. Please
contact the after sales service.
5 Control
5.1 Brightness of the temperature
display
You can adjust the brightness of the temperature display to the
light conditions of the room in which the appliance is installed.
5.1.1 Adjusting the brightness
The brightness is adjustable between
h0
(no illumination) and
h5
(maximum luminosity).
u
To activate the setting mode: press the SuperFrost button
Fig. 3 (18)
for about 5 s.
w The display indicates
c
.
w
The menu symbol
Fig. 3 (10)
shines.
u
Using the Up setting button, freezer compartment
Fig. 3 (15)
or Down setting button, freezer compartment
Fig. 3 (16)
,
select
h
.
u
To confirm: briefly press the SuperFrost button
Fig. 3 (18)
.
u
To make the display brighter: press Up button,
freezer compartment
Fig. 3 (15)
.
u
To make the display darker: press Down button,
freezer compartment
Fig. 3 (16)
.
u
To confirm: press SuperFrost button
Fig. 3 (18)
.
w
The brightness is adjusted to the new value.
u
To deactivate the set-up mode: press On/Off button, freezer
compartment
Fig. 3 (17)
.
-or-
u
Wait for 5 minutes.
w
The temperature is indicated again in the temperature
display.
5.2 Child proofing
The child-proofing function enables you to make
sure that the appliance is not inadvertently switched
off by playing children.
5.2.1 Setting the child lock function
u
To activate the setting mode: press SuperFrost button
Fig. 3 (18)
for about 5 s.
w
c
flashes on the display.
w
The menu symbol
Fig. 3 (10)
shines.
u
Briefly press the SuperFrost button
Fig. 3 (18)
.to confirm.
When
c1
is indicated in the display:
u
Tto activate the child lock, briefly press the
SuperFrost button
Fig. 3 (18)
.
w The child lock symbol
Fig. 3 (9)
shines.
c
flashes in the
display.
When
c0
is indicated in the display:
u
to deactivate the child lock, briefly press the SuperFrost
button
Fig. 3 (18)
.
w The child lock symbol
Fig. 3 (9)
goes out.
c
flashes in the
display.
u
To deactivate the set-up mode: press On/Off button, freezer
compartment
Fig. 3 (17)
.
-or-
u
Wait for 5 minutes.
w
The temperature is indicated again in the temperature
display.
5.3 Door alarm
For refrigerator / BioFresh compartment and freezer compart-
ment
Control
10
* Depending on model and options