New Buck Corporation 261 User Manual
Page 38
B-1. Rear Exit Installation
HOW TO LOCATE CHIMNEY EXIT, AND INSTALL
B-1. Vertical Rear Exit using (6" DVL Close Clearance Pipe and any
Listed 2100° UL HT chimney, and Listed 2100° UL HT T-Box assembly).
With standard close clearance shield and pipe shield
NOTE: For minimum clearances (See Page 37, Figure 31).
1. Measure up so there will be at least 1/4" rise per foot of horizontal connector pipe,
maintaining clearances as noted in (Page 37,Figure 31). This will give you
the center of the hole for the chimney penetration.
2. After locating the center of the penetration, install the tee-box and chimney as per the
chimney manufacturer's specifications.
3. Connect the DVL close clearance pipe to the tee-box per manufacturer’s instructions,.
DVL close clearance pipe is to be connected with (3) sheet metal screws or rivets to
New Buck Cast Collar, after New Buck Cast Collar has been
attached to stove. ( See Page 37 ,Figure 32.).
36