Blue Rhino GWU501E - Manual (Page 11)

Replacing Pilot and Control Valve Series GWU501E, GWU511A, GWU512A LP Gas 606030 11
For assistance call 1.800.762.1142.
Step 9
A. There are two small phillips screws in the emitter bottom on either side of the burner. Remove these screws.
B. Follow the copper burner supply tube down to the top of the control valve. You will see a nut that connects the burner supply tube to the
control valve. Using a 5/8” wrench, remove the nut holding the burner supply tube to the control valve.
C. Remove the burner and burner supply tube by pulling the burner straight up. Be careful not to damage the wires on the pilot or damage
the burner supply tube.
D. Set components aside for later reinstallation.
(1 shown)