Philips AVENT Écoute-bébé DECT - Manual (Page 6)

6
• The display goes on and the battery status
indications show that the parent unit is
charging. For battery status indications,
see ‘Battery charge indications’ in chapter
‘Functions and feedback on the parent unit’.
3
Leave the parent unit in the plugged-in
charger until the rechargeable batteries
are fully charged.
D Note:
When you start using the baby monitor, it takes
four charge and discharge cycles before the
rechargeable batteries reach their full capacity.
4 Using the baby
monitor
4.1 Positioning the baby
monitor
B Warning:
Keep the baby unit out of the reach of the baby.
Never place the baby unit inside the baby’s bed
or playpen.
1
Because the cord of the baby unit presents
a potential strangulation hazard, make sure
that the baby unit and its cord are at least
1 metre/3.5 feet away from your baby.
2
To prevent a high-pitched sound from one or
both units, make sure the parent unit is at least
1 metre/3.5 feet away from the baby unit.
3
Slide the lid of the compartment for the
rechargeable batteries back onto the parent
unit. Push the lid home until it locks into place
with a click.
3.2.2 Charging the parent unit
Charge the parent unit before you use it for the
first time or when the parent unit indicates that
the batteries are low.
Important: You have to charge the parent
unit for the full 10 hours to have a cordless
operating time of 18 hours.
1
Insert the small appliance plug of the adapter
in the socket on the back of the charger.
Put the adapter in a wall socket.
2
Put the parent unit in the charger.