Philips Télécommande universelle - Manual (Page 8)

16 BACK jumps back one level in the menu or turns off the
menu.
17 TV / STB / DVD device mode selection keys:
• select TV, STB or DVD mode.
• blink when the remote control is set up for the
selected device.
• light up when a remote control command is sent
to the selected device.
Note
If the device does not respond at all, or not to all of the key commands,
follow the instructions under ‘2.3 Setting the remote control’.
4 Extra possibilities
4.1 Adjusting device selection (Mode keys)
The SRU 5130 is default set for operating TV, STB or DVD.You can select
the device you wish to operate with the TV, STB and DVD keys. Each
mode key allows operation of one device only. If desired, you can
program the keys to select a different kind of device. For example, if you
want to operate a second TV. In the following example you will see how
to configure the DVD key for a second TV.
Switch on the second TV.
Press the DVD key to select DVD.
• The key lights up.
Then keep keys 1 and 6 on the SRU 5130 pressed simultaneously for
three seconds, until the DVD key
lights up.
12
12
3
11
11
2
1
8
Extra possibilities
ENGLISH