Buffalo Technology NFINITI WZR-HP-G300NH - Manual (Page 21)

WZR-HP-G300NH User Manual 20
Chapter 4 Configuration
The web-based configuration tool lets you change advanced settings for the AirStation. Don’t
change these settings unless you know what you’re doing.
How to Access the Web-Based Configuration Utility
To configure the AirStation’s advanced settings manually, log in to the web-based configuration
utility as shown below.
1
2
3
Launch a web browser.
Enter the AirStation’s LAN-side IP address in the
address field, and press the [Enter] key.
Note: · The AirStation’s default LAN-side IP address depends on the position of the mode switch.
In router mode: 192.168.11.1
In bridge mode: 192.168.11.100
Note: If the router switch is set to [AUTO] and the unit is in bridge mode, then the AirStation’s IP
address was assigned by an external DHCP server.
· If you changed the IP address of the AirStation, then use the new IP address.
When this screen appears, enter [root]
(in lower case) for the user name and the
password that you set during initial setup.
Click [OK].
Note: · By default, the password is blank (not set).
· If you forget your password, hold down
the Reset button (page 12) to initialize all
settings. The password will then be blank.
Note that all other settings will also revert to
their default values.