Antenna grounding – Bose Lifestyle Surround Sound Speaker System User Manual

Page 4

English

December 20, 2001

AM262842_00_V.pdf

Important Safety Instructions

Antenna grounding

Example of antenna grounding as per National Electrical
Code, ANSI/NFPA 70.

Note to CATV system installer

This reminder is provided to call the CATV system
installer’s attention to Article 820-40 of the NEC (of USA)
that provides guidelines for proper grounding. In particu-
lar, it specifies that the cable ground shall be connected
to the grounding system of the building, as close to the
point of cable entry as is practical.

18. Use proper power sources – Plug the product into

a proper power source, as described in the operating
instructions or as marked on the product.

19. Avoid power lines – Use extreme care when

installing an outside antenna system to keep from
touching power lines or circuits, as contact with
them may be fatal. Do not install external antennas
near overhead power lines or other electric light or
power circuits, nor where an antenna can fall into
such circuits or power lines.

20. Ground all outdoor antennas – If an external

antenna or cable system is connected to this
product, be sure the antenna or cable system is
grounded. This will provide some protection against
voltage surges and built-up static charges.

Section 810 of the National Electrical Code ANSI/
NFPA No. 70 provides information with respect to
proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors,
location of antenna-discharge unit, connection to
grounding electrodes, and requirements for the
ground electrode. Refer to the antenna grounding
illustration on this page.

Antenna lead in wire

Antenna discharge unit

(NEC Section 810-20)

Grounding conductors

(NEC Section 810-21)

Power service grounding
electrode system

(NEC ART 250, Part H)

Ground clamps

Ground clamp

Electric service

equipment