Britax FRONTIER 85 SICT - Manual (Page 19)

34 35
13 Pull the adjuster strap to
tighten the harness.
* Pull the harness adjuster away
from the child seat (parallel
to the ground) to tighten. See
page 39.
12 Replace the belt shield over
the harness straps and yoke.
Checklist
9 Check that the harness straps are not twisted.
9 Ensure the chest clip and HUGS™ chest pads face outward.
9 Check that the adjuster strap is not twisted.
9 Check that the harness yoke is in the proper orientation and
that the harness straps are nested securely onto the yoke.
IMPORTANT: Check the harness straps and attachments before
using the child seat.
Check that Harness
Yoke hangs as shown,
and that Harness
Straps are nested
securely on the yoke
Check that the
Chest Clip and
HUGS™ Chest
pads face outward
Check that
Harness Straps
are not twisted
Check that Adjuster
Strap is not twisted
FRONT BACK
Positioning the Child Seat: Booster Mode
WARNING!
• Position forward-facing only in a seating position with a
lap-shoulder belt.
• Use only the vehicle’s lap and shoulder belt system when
securing a child in booster mode. Never secure a child
with a lap belt only in booster mode.
• Always secure the unoccupied child seat.
• If the LATCH anchors in your vehicle prevent proper
vehicle belt fit across your child you cannot use LATCH to
position this seat in booster mode. See below.
The vehicle belt fits properly
when the lap part sits low across
the child’s upper thighs (b) and
the shoulder part lies across the
center of the child’s chest and
does not contact the child’s neck
when routed through the upper
belt guide (a).
a
b
Switching Between Modes