Buffalo Technology WLI-TX4-G54HP - Manual (Page 7)

If you have a Windows 98/ME/2000/XP machine with a CD-ROM drive available on your
computer network, the Ethernet Converter Manager makes it simple to configure the
Ethernet Converter. The following steps will guide you through configuring the Ethernet
Converter via the Ethernet Converter Manager.
Connect one of the Ethernet Converter's LAN ports to an open port on your network's
router, switch or hub with the included network patch cable. If there are no ports
available, you can temporarily remove a computer or other connected device and plug
the Ethernet Converter to that port. You can plug the Ethernet Converter directly to the
configuring computer, but will have to configure settings manually as described on page
17.
Once the network cable has been plugged in, plug the Ethernet Converter's AC Adapter
into an available power outlet. Then attach the power connector to the back of the
Ethernet Converter. The boot up process takes 30 seconds and is complete when both
the Wireless and Ethernet LEDs are lit.
Return to the PC designated for configuration and insert the included Ethernet Converter
CD-ROM into the PC's CD-ROM drive.
The Ethernet Converter Utility should launch automatically. If it does not, browse your
CD-ROM drive in Windows and run the setup.exe program.
Configuration with Ethernet Converter Manager