Buffalo Technology WHR-G54S - Manual (Page 71)

1
On the left-side menu, click on Wireless Config, and
then Repeater.
Repeater-Bridge (WDS) must be set to Enable. If it is
not, change it to Enable in the drop down menu and
click Apply. After the AirStation reboots, the screen
will refresh. Click Edit Registered WDS Partners.
Under Add New WDS Partner Access Point, enter the
wireless MAC address of the second AirStation, the
one that you want to form a bridge with. You can
get this from the bottom of the second AirStation (see
above). Enter it with each pair of digits separated
by a colon, e.g. 000D0B10F778 would be entered
“00:0D:0B:10:F7:78”. Press New Partner when done.
The AirStation will reboot, and when the screen
refreshes, the second AirStation’s MAC address will
be listed under Bridgeable Access Points.
Configuring a WDS Bridge