Buffalo Technology WHR-G54S - Manual (Page 38)

Network Configuration (Intrusion Detector)
To enable intrusion detector, choose
Enable or Enable (Apply packet filter rules)
from the Intrusion Detector drop-down
box. If packet filter rules are applied,
packets will be filtered with packet filter
rules before Intrusion Detector is applied.
Blocking IP spoofing blocks packets from
devices using an IP address that is not
their own.
In the Threshold Value box, enter the
number of times an event has to occur
before you receive notification.
To configure your email alerts, enter your
email address and mail server information.
You may make up a sender email address,
such as “[email protected]”. Alert emails will appear to come from this address.
Intrusion detector also blocks unauthorized access attempts and suspicious traffic from
WAN-side devices (the internet).