General oven information – Bosch HBL 75 User Manual
Page 12
Bosch HBL7 / HBN7 Oven Use and Care Manual
Oven Features
Page 10
Before using your Bosch oven for the first time remove
all packing and foreign materials from the oven(s). Any
material of this sort left in the oven(s) may melt and/
or burn when the oven(s) is(are) used.
Flashing Symbols or Numbers
Signals an incomplete setting and calls for another step
or START to be touched.
Beeps
Signals that more information must be entered or
confirms the receipt of an entry. Beeps also signal the
end of a function or an oven fault.
Probe Symbol
The probe symbol will be displayed when the probe is
inserted into the probe receptacle. The internal
temperature of the meat is also displayed in place of
the oven roasting temperature. The selected probe
temperature can be displayed by touching
TEMPERATURE. Oven temperature can be displayed
by touching TEMPERATURE two times.
Lock Symbol
Displays during the Self-Clean mode and when the
door is locked. Do not attempt to open the door when
the lock symbol or UNLOCKING DOOR is
displayed. Door can be opened when the symbol no
longer appears.
General Oven Information
Power Failure
After the power returns to the oven, the clock displays
the time when the power was lost or turned off.
Default Settings
The cooking modes automatically select a suitable
temperature. These can be changed when a different
one is needed.
F Number Codes
These codes are displayed when there is a problem
with the signal sent to the electronic control board.
See Solving Operational Problems, Page 39.
Convection Fan
The convection fan operates during any convection
mode. When the oven is operating in the convection
mode, the fan will turn off automatically when the door
is opened. The convection fan will run during the
preheat time for specific modes.
Component Cooling Fan
Activates during any cooking or self-cleaning mode to
cool inner components and outer door surfaces. This
air is exhausted through the vent located above the
oven door. It continues to run until components have
cooled sufficiently.