Bloomfield 8541 User Manual

Page 17

SERVICING INSTRUCTIONS (continued)

IMPORTANT:

When replacing

water faucet coil, also replace
seal gaskets.

NOTE:

Any abrasion or

roughness on the flat end of the
seat cup will require replacing
the seat cup:

Work the seat cup out of the
bonnet and off of the end of the
stem.

Install a new seat cup, making
sure the knob on the stem is
fully inserted into the pocket of
the seat cup, and the skirt of the
seat cup is fully inserted into the
bonnet.

REPLACE TIMER ASSEMBLY

Unplug power cord or turn circuit breaker OFF.

Remove front panel. Remove knob and three screws holding
timer to bracket. Disconnect wiring to timer.

Reassemble in reverse order.
Adjust timer as described on page 13

REPLACE HOT WATER FAUCET COIL

Symptom: Brewer drips continuously from brew head, except
when faucet valve is turned OFF.

Remove tank lid assembly per above.

Remove two hex nuts hot water coil to cover. Pull coil from
mounting holes.

Reassemble in reverse order.

REPAIR HOT WATER FAUCET

Remove top panel and turn faucet valve OFF.

Unscrew aerator cap from faucet and remove handle retaining
clip. Do not let faucet body turn.

Pull bonnet assembly from faucet body.

Examine the interior of the faucet body and the surface of the
seat cup. Clean out any debris in the faucet body, using a stiff
bristle brush if necessary.

Examine the aerator. Clean any debris from the screen or flow
straightener, using a stiff bristle brush if necessary.

Reassemble in reverse order.

REPLACE BREW READY LIGHT or BREW BUTTON

Unplug power cord or turn circuit breaker OFF.

Using Switch Removal Tool (p/n 83209) or a thin screwdriver, pry
light or switch from mounting hole. Disconnect leads.

Reassemble in reverse order.

5804

ners

anu

al Kof

-K

ing™

ewe

This manual is related to the following products:

8573