Philips Mando a distancia universal - Manual (Page 11)

5. Replacing the batteries
When the battery status indicator ( ) on the display starts blinking, battery power is
low and you should replace the batteries. All user settings will be retained when the old
batteries are removed.
1
Press the cover inward, slide it in the direction of the
arrow and remove the cover.
2 Insert 3 AAA/R03 batteries noting the + and -
configuration inside the battery compartment.
3
Place the cover back and click it firmly into place.
6. Support
Troubleshooting
• Problem
– Possible cause / solution
• The device you want to operate does not respond at all when a key is pressed.
– Point the remote control at the device and make sure that there are no obstructions
between the remote control and the device.
– Make sure the function you wish to operate is available on the device.
– Check if the battery status indicator ( ) on the display blinks (low battery power).
If this is the case, insert new batteries.
• The device you want to operate does not respond properly when a key is pressed.
– Maybe the wrong code is programmed for the device during setup.
Try setting up the remote again. If the device still does not respond, call our helpline.
– Check if the battery status indicator ( ) on the display blinks (low battery power).
If this is the case, insert new batteries.
• The teletext keys do not work.
– Find out whether your TV is equipped with teletext.
• You have difficulties operating all of the functions on your device.
– Maybe the remote control has to be adapted to the model of the device.
Call our helpline for details.
• ERROR appears on the display while adding an extra (advanced) function or when
trying to learn a key.
– No signal from the original remote control is received for 20 seconds and the SRU 5150
stopped the adding / learning process. Start again from step 1.
– An SRU 5150 key is pressed before a signal is detected and the SRU 5150 stopped the
adding/learning process. Start again from step 1.
– The function you try to add is not available on the original remote control.
– Make sure the original remote control is working properly.
– Make sure the remote controls are properly aligned.
– The IR signal of your original device is out of range. The SRU 5150 can only learn IR signals
with a carrier signal of 30-60kHz.
11
English
Instructions for use
Manual_SRU5150_87 24-04-2007 15:47 Pagina 11