Philips Wake-up Light User Manual
Page 8
- If you share a bedroom with someone else, this person may unintentionally wake up from the
light of the appliance, even though this person is further removed from the appliance. This
phenomenon is the result of differences in light sensitivity between people.
- The power consumption of the appliance is lowest if the radio, the USB playback function and
the lamp are switched off.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
preparing for use
setting the clock
1
Put the plug in the wall socket.
, The hour indication on the display starts flashing to indicate that you have to set the clock
time (Fig. 6).
2
Press the menu - or + button to select the hour.
3
Press the SELECT button to confirm.
, The minute indication starts flashing (Fig. 7).
4
Press the menu - or + button to set the minutes.
5
Press the SELECT button to confirm.
, The appliance leaves the menu and the display shows the set clock time.
The appliance is now ready for use.
Note: The method described above only applies when you plug in the appliance for the first time, when
there has been a power failure or when the mains plug has been removed from the wall socket for more
than 15 minutes. In these cases, the hour indication flashes to indicate that you have to set the clock
time. In all other cases, you have to use the menu to set the clock time (see section ‘Menu functions’ in
chapter ‘Using the appliance’).
using the appliance
menu functions
Below you find a description of all functions that can be set in the menu. These functions appear in
the menu in the following order:
- Clock time
- Alarm time 1
- Alarm time 2
- Alarm sound
- Sunset simulation
- Display brightness
You can set the menu functions in the following way:
1
Press the MENU button to enter the menu (Fig. 8).
Note: If you do not press any button within 30 seconds, the appliance exits the menu and the display
shows the clock time again.
2
Press the menu - or + button to select a function. (Fig. 9)
3
Press the SELECT button to enter this function (Fig. 10).
4
Press the menu - or + button to change a setting. (Fig. 9)
EnglisH
8