Belkin F5D7010 - Manual (Page 14)

USING THE BELKIN WIRELESS LAN UTILITY
Diagnostics Page
This Page allows you to perform several diagnostic tests that are available for
your Belkin Wireless Network adapter.
Control Registers
This test verifies the read and write capabilities of the network controller
registers by writing various values to the registers and verifying the result. The
device driver uses these registers to perform network functions such as sending
and receive information. If the test fails, the network adapter may not work
properly.
SPROM Format Version
This test verifies the content of the SPROM by reading a portion of the SPROM
and computing the checksum. The test fails if the computed checksum is
different than the checksum stored in the SPROM.
USING THE BELKIN WIRELESS LAN UTILITY
(d) WEP
Will display “Off” when encryption is disabled, “64-bit” when 64-bit encryption
is enabled, and “128-bit” when 128-bit encryption is enabled.
(e) Ad-Hoc Networks Only
Check this box to display available ad-hoc networks only.
(f) Advanced
Displays additional information about the selected network.
(g) Freeze
Takes a “snapshot” of the signal strength at the time of the site survey. Click
again to unfreeze.
24 25