Blaupunkt SAN FRANCISCO RDM 127 - Manual (Page 17)

47
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Displaying the selected programme
type
• Press << or >>.
The programme type selected last will be
displayed briefly.
Selecting a programme type
a) Using the preset buttons
When PTY is switched on, you can use
the preset buttons 1-6 to select the
programme types stored at the factory.
• Press one of the presets 1 - 6.
The selected programme type will be
displayed for two seconds.
If you wish to listen to a station with
this PTY,
• press / to start seek tuning op-
eration.
If the system is unable to find a station of-
fering the selected programme type, the dis-
play will show “NO PTY” and a beep tone
will be released. The station received be-
fore starting seek tuning will be tuned in.
You can assign different programme types
to each preset position. Please refer to the
next chapter “Storing programme types”.
Storing programme types
One programme type was assigned to each
of the preset buttons 1-6 at the factory.
If desired, you can also store other availa-
ble programme types.
To do so, make sure that “PTY” lights up in
the display.
•
If necessary, press the PTY button to
switch on the function.
• Select a programme type using but-
tons << >> and
• hold down the desired preset button
(1-6) until you hear a beep.
Now the selected programme type can be
recalled by pressing this preset. For this the
PTY function must be active.
Scanning stations with PTY-SCAN
Condition: “PTY” must appear in the display.
• Press the SC button.
All received stations offering the selected
programme types will be scanned.
To switch off PTY-SCAN:
•
Press SC once again.
b) Using the << >> buttons of the rocker
switch
When PTY is switched on, you can se-
lect a programme type using buttons
<< >>.
• Press << or >>; the programme
type selected last will be displayed
for three seconds.
• During this period press >> (for-
wards) or << (backwards) to select
the desired type.
• Press << or >> as many times as
required.
If you wish to listen to a station offering
the selected PTY,
• press / to start seek tuning op-
eration.
If the system is unable to find a station of-
fering the selected programme type, the dis-
play will show “NO PTY” and a beep tone
will be released. The station received be-
fore starting seek tuning will be tuned in.
San Francisco gb® 29.05.2002, 12:15 Uhr 47