Blaupunkt SAN FRANCISCO RDM 127 - Manual (Page 15)

45
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Notice:
Should you tune in a station which has al-
ready been stored before on another mem-
ory bank, the corresponding preset button
and the memory bank will briefly flash in the
display.
Automatically storing the
strongest stations with Travel-
store
You can automatically store the six most
powerful FM stations of your current recep-
tion area sorted according to their signal
strength. This function is particularly con-
venient on longer trips.
•
Press the FM T button for two seconds.
“T-STORE” will appear in the display.
The six strongest FM stations will be auto-
matically stored on the memory bank “T”
(Travelstore). When this process has been
completed, the radio will play the first sta-
tion.
If desired, stations can also be stored man-
ually on the Travelstore bank (see “Storing
stations”).
Recalling stored stations
You can recall any stored station at the touch
of a button.
•
Select the waveband by pressing FM T
or M•L. On FM, also choose the corre-
sponding memory bank by briefly
pressing the FM
T button as many
times until the desired bank appears in
the display.
• Press the corresponding preset button
briefly to recall the station.
Scanning stored stations with
Preset Scan
You can have all of the stored stations briefly
scanned on all wavebands.
Note that the Preset Scan function can only
be started if PTY is switched off (“PTY” does
not light up in the display).
•
Press the PTY button if required.
To start Preset Scan:
•
Press SC/MIX for approximately two
seconds.
All of the stored stations of the adjusted
waveband will be scanned one after the oth-
er. The memory bank and preset position of
the currently scanned station will flash in the
display.
To select a scanned station and switch
off Preset Scan:
•
Press SC/MIX briefly.
Scanning stations with
Radio-Scan
You can also scan all stations which can be
received.
To start the Scan function:
•
Press SC/MIX briefly.
The scanned frequency or the station name
will start flashing in the display. During the
actual scanning process “SCAN” will be dis-
played.
To select a scanned station and switch
off the Radio-Scan function:
•
Press SC/MIX briefly.
If no station is selected, the scan function
will be automatically switched off after the
frequency band has been run through com-
pletely. The unit will tune in the station lis-
tened to before starting the scan.
Changing the scan time
The scan time can be changed from be-
tween five to a maximum of 30 seconds.
Please refer to chapter “DSC programming
- SCANTIME”.
San Francisco gb® 29.05.2002, 12:15 Uhr 45