Burley Nomad - Manual (Page 9)

B U R L E Y T R A I L E R O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N UA L
Installing the Tow Bar for
the Nomad
™
Tip the trailer onto its back end.
Slide the tow bar onto the pivot
pin at the left front. Remove the
hairpin cotter and lock pin from
the front tow bar receptacle, rotate
the tow bar up into place, and
snap it into the two plastic tow bar
receptacles. Push the lock pin fully
into the front tow bar receptacle.
Rotate the lock pin and locate the
hole in it, between the receptacle
and the trailer frame. Anchor the
lock pin by inserting the hairpin
cotter all the way into the hole in
the lock pin.
Never operate the Nomad ™ trailer without tow bar lock pin and hairpin
cotter locked in place. An unlocked tow bar can loosen or detach and
cause an accident, resulting in serious injury.
WARNING
Installing the Tow Bar for the Flatbed
™
Rotate the tow bar up into the plastic tow bar
receptacle at the front frame. To lock the tow
bar in place, slip the retaining pin through the
hole in the tow bar receptacle and close the
pin (see illustration).
. Anchor Lock Pin
with Hairpin Cotter
. Anchor Lock
Pin with
Hairpin Cotter
1. Slide
Tow Bar
onto
Pivot Pin
2. Rotate Tow Bar
into Place
5. Lock Pin and Hairpin
Cotter Locked in Place
(viewed from underside)
The retaining pin must be locked
in place before using the Flatbed ™
trailer; otherwise, the tow bar
could shift and cause an accident
and serious injury.
WARNING