Bloomfield 9421 (SS2-HE) - Manual (Page 17)

PROGRAMMING (continued)
15
Brew Volume
The 1st key is the Standard
Brew Volume.
When a brew volume other
than standard brew volume is
selected, the Brewer will
complete that brew then return
to the standard brew volume
automatically.
7. Automatic Start-Up in Previous Mode:
If the Satellite Brewer automatic timer is OFF (the factory
setting) and power is disconnected, the brewer will start up
when power is restored, in the mode it had been in prior to
the power disconnection. If the Satellite Brewer has the
timer setting ON and power is disconnected, the brewer will
start up in the mode that it should be in at the time the power
is restored.
8. Brew Volume:
The Brewer can have up to 3 different brew volumes on each
side. When a volume other than the standard, or first brew
volume, is selected, the Brewer will complete that volume
and then automatically reset to the standard, or first brew
volume.
To view, press the individual volume key. The brew volume
will be displayed on the screen for 3 seconds. If there is
no brew volume for a specific key, the screen will read “no
volume prog”, (i.e. no volume programmed).
9. Clock
Time – Battery Backup. The Satellite Brewer has a battery
backup system which will maintain the proper time during
power failures, or when the brewer is unplugged (even for
very prolonged periods of time). Normally there will not be a
need to set the time except for Daylight Saving Time
changes, or moving the brewer to different time zones.
10. Changing Day and Time: To change time, in the OFF
mode, press the 2nd key twice followed by the 1st key twice
to access the time change mode. In the time change mode
he screen will read “Day:” followed by the current day
setting. Use the 6th key to advance the day, or the 5th key
to reverse.
When day has been properly set, press the 3rd key. The
screen will now read “Time:” with the set time on the screen,
the hour and am or pm flashing. Use the 6th key to advance
the hour, or the 5th key to reverse, making sure that the am
or pm is correct.
When the hour and am/pm is correctly set, press the 3rd key,
and the screen will read “Time:” with the set time on the
screen, minutes flashing. As previously, use the 5th or 6th
keys to adjust the minutes, and press the 3rd key when
complete. The Brewer will return to the off mode. (Changing
time can also be done in the regular programming mode.)