Whirlpool WED7500VW - Manual (Page 6)

6
5.
Select the desired cycle
Select the desired cycle for your load. See the “Cycle Guide”
for more information about each cycle.
NOTE: Most loads may be dried using the Normal dryness
level, which is shown in bold letters on the control panel.
Normal is the energy preferred dryness level and will use
the least energy.
6.
Press START to begin cycle
Press and hold the START button to begin the cycle.
To stop your dryer at any time:
Turn the Cycle Control knob to the STOP position, push the
POWER button, or open the door.
To restart the dryer:
1. Close the door.
2. Select a new cycle and temperature (if desired).
3. Press the START button.
To change the cycle or temperature after pressing
START:
1. Open the dryer door.
2. Press the TEMPERATURE button to change the
temperature (if desired).
3. Turn the cycle knob to the new desired position.
4. Press the START button.
DRYER CARE
CLEANING THE DRYER LOCATION
Keep dryer area clear and free from items that would
block the air flow for proper dryer operation. This includes
clearing piles of laundry in front of the dryer.
CLEANING THE DRYER INTERIOR
To clean dryer drum
1. Use a mild hand dish detergent mixed at a low
concentration with very warm water, and rub with
a soft cloth.
2. Rinse well with a wet sponge or towel.
3.
Press POWER
Press the POWER button to turn on the dryer.
4.
Press TEMPERATURE
Press the TEMPERATURE button to select the recommended
temperature setting for the type of load being dried.