Whirlpool WED7500VW - Manual (Page 4)

4
CONTROL PANEL AND FEATURES
START BUTTON
Press to start a cycle. Indicator light will glow to indicate
the cycle has started.
TEMPERATURE BUTTON
The Temperature Control button lets you choose between
a normal and low drying temperature.
Normal
The Normal temperature setting is for sturdy fabrics, such
as cotton, linen, and denim. If the Temperature Control
button is not pressed in, the temperature setting is Normal.
Low
The Low setting is for synthetics, such as cotton/polyester
blend, rayon, acetate, washable silk, or nylon. If the
Temperature Control button is pressed in, the temperature
setting is Low.
NOTE: Always refer to the care label on the garment to
determine whether it can be tumble dried.
1
2
4
5
POWER
Press to turn the dryer on and off. Press again to stop/
cancel a cycle at any time.
CYCLE CONTROL KNOB
Use your dryer’s Cycle Control knob to select available
cycles on your dryer. Turn the knob to select a cycle
for your laundry load. See “Cycle Guide” for detailed
descriptions of cycles.
POWER INDICATOR
This light flashes when the power is on and glows when
a cycle is running.
1
2
3
4
5
3
CYCLE GUIDE — SENSOR DRY CYCLES
Cotton/Linen
Heavy cottons and denims Extra Dry Normal
Cottons and linens Normal Normal
Synthetics
White and colorfast permanent press Normal Low
White and colorfast items that require ironing Iron Dry Low
Polyester/acrylic blends, rayon, acetate Damp Dry Low
Washable silk and nylon Damp Dry Low
Items to dry: Cycle: Temperature
Setting:
Use Sensor Dry Cycles for better fabric care and energy savings
When you are using the GentleBreeze ™ Drying System with IntelliDry ® Sensor, two metal strips located in the dryer determine the
dryness of the load. When there is moisture left in the clothes, the dryer will continue to run. As clothes begin to dry, the amount of
water left in the clothes decreases, and the timer advances through the remainder of the cycle. When the selected dryness level is
reached, the dryer goes into a cool-down period.
Sensor dry cycles may be used for most loads. Sensor dry cycles give the best drying results in the shortest time. Drying time varies
according to the type of fabric, size of the load, and dryness setting.
After drying a load, check the dryness.
n If the load is drier than you like, select a setting closer to Iron Dry the next time you dry a similar load.
n If a load is not as dry as you like, complete drying using a Timed cycle. Select a setting closer to Extra Dry the next time you dry
a similar load.
OPERATING INSTRUCTIONS
END OF CYCLE SIGNAL
The dryer sounds a signal to let you know when the cycle is
complete. The signal is not adjustable and cannot be turned off.
The signal is helpful when you are drying permanent press,
synthetics, and other items that should be removed promptly
at the end of the cycle.