Whirlpool LTG5243DQ - Manual (Page 5)

4.
Insert a rear leveling
leg into the hole in the rear corner.
Push the leg in until it snaps into
place. Do the same thing with
the other leveling leg in the other
rear corner.
Panel D
Now start...
With washer/dryer in laundry area.
Product dimensions...
(Shown with legs extended 1 inch from
bottom of washer)
Most installations will require at least 5 inch
clearance behind the dryer for the dryer
vent.
Location must be large enough to fully open
dryer door.
Excessive Weight Hazard
Use two or more people to move and
install washer/dryer.
Failure to do so can result in back or
other injury.
Truck only from rear to prevent product
damage.
1.
Put on safety glasses and gloves.
5.
Push up on one
leg. Check to see if the
other leg goes down.
Check the other leg in the
same way. (If the legs do
not adjust, repeat Step 4.)
1 drain
hose clamp
rear legs
front legs
Numbers
correspond
to steps.
4.
5.
4.
5.
6.
6.
8.
1 plastic beaded strap
1 small clamp
4-3/8"
recess
depth
1-1/2"
14-1/4"
recess width
rear view
cold
water inlet
28-5/8"
24"
drain
outlet
27-1/2"
exhaust
outlet
38"
19"
2.
Remove
cardboard
shipping base.
3.
Remove parts from package. Check
that all parts were included.
4 flat,
water-hose
washers
7.
12" 12"
2.
71-3/4"
27-1/4"
side view
38"
5-1/4"
21-5/16"
15-3/8"
32-1/8"
57"
47"
51-1/2"
27-5/8"
WARNING
Recessed and closet
installation instructions
48 sq. in. *
0"
side view
Recessed installation
Closet installation
24 sq. in. *
24 sq. in. *
3"
3"
front view
side view
48 sq. in. *
0"
12"
0"
dryer
washer
Additional clearance for wall, door and floor
molding may be required. Additional space may
be needed for exhaust elbow.
WARNING - To reduce the risk of fire, this
appliance MUST BE EXHAUSTED OUTDOORS.
Unobstructed air openings are minimum for closet
door. Louvered door with equivalent air openings
is acceptable.
Additional clearance for wall, door and floor
molding may be required.
Additional
space may
be needed
for exhaust
Minimum installation spacing
1"
closet
door
closet
door
front view
0"
This washer/dryer may be installed in a
recessed area or closet.
The installation spacing is in inches and is the
minimum allowable. Additional spacing
should be considered for ease of installation,
servicing and compliance with local codes
and ordinances. No other fuel-burning
appliance shall be installed in the same
closet as the washer/dryer.
If closet door is installed, the minimum
unobstructed air openings in top and
bottom are required. Louvered doors with
equivalent air openings are acceptable.
Other installations must use the minimum
dimensions indicated.
* Opening is minimum for closet door. Louvered
door with equivalent air openings is acceptable.