Whirlpool LTG5243DQ - Manual

Part No. 3405971 Rev. C
Gas Thin Twin
Washer•Dryer – 120 Volt
Benton Harbor, Michigan 49022
Part No. 3405971 Rev. C
©2001 Whirlpool Corporation
Installation Instructions
Gas Thin T
win
IMPORTANT:
Installer: Leave Installation Instructions
with the homeowner.
Homeowner: Keep Installation Instructions
for future reference.
Save Installation Instructions for local
electrical inspector’s use.
IMPORTANT:
Read and save
these instructions.
Printed in U.S.A.
When moving the
washer/dryer...
• Disconnect the power supply cord, then
tape securely to the washer/dryer.
• Shut off the gas supply valve in the gas
supply line.
• Disconnect the flexible gas connector and
fittings from gas supply line and cap the
gas supply line.
• Tape the flexible gas connector to back
panel of the washer/dryer. DO NOT
DISCONNECT THE FLEXIBLE GAS
CONNECTOR FROM THE WASHER/DRYER.
• Tape the dryer drum to the front panel.
Tape the lint screen in place. Tape the
dryer door closed.
• Wedge a blanket between the tub ring
and cabinet top to restrict tub movement.
• Turn front leveling legs all the way in.
Before installing the washer/dryer in your new
home, check with your gas supplier or dealer
to see that your dryer is equipped with the
correct burner for the particular type of gas
in your new home. Burner information may
be found on the model/serial rating plate in
the door well of the dryer.
If washer/dryer does
not operate properly...
Check the following to be sure that:
1. Electrical supply is connected.
2. House fuse is intact and tight or circuit
breaker is not tripped.
3. Washer lid or dryer door is closed.
4. Round shipping piece has been
completely removed.
5. Controls are set in a running or “ON”
position.
6. Dryer start button has been firmly pushed.
7. Gas shutoff valve is open in supply line.
If you need
assistance...
Check your Use and Care Guide for a toll-
free number to call, or call the dealer from
whom you purchased this appliance. The
dealer is listed in the Yellow Pages of your
phone directory under “Appliances —
Household — Major — Service and Repair.”
When you call, you will need the
washer/dryer model number and serial
number. Both numbers can be found on the
model/serial rating plate located on the
door well behind the dryer door.